Chip Quik SMD291AX No-Clean Solder Paste - 63Sn/37Pb Alloy in 5cc Syringe (15g) for Electronics Repair, PCB Assembly, and SMD Soldering

I accidentally bumped the batter connector off of an iPod Classic, and could not get the pads properly soldered with a normal spool of solder and looked into alternatives. It has been well over a decade that I had to solder some SMDs, so I forgot about liquid solder/solder paste and after seeing a couple Youtube videos using it I figured it is much cheaper than replacing the logic board, so if it doesn't work, no big deal.I was able to clean off the pads and put a drop of paste on all three pads and easily solder it back down with a wide tip. Since I didn't have good precision tweezers, I had a small bridge between two pins, which I was able to eventually get cleaned up. By no means meant as a problem with the paste, but just be careful not to use too much. :)