NTE Electronics SW02-5 No-Clean Solder Wick - 4 Blue Strips, 0.098" Width, 5 Feet Length - Perfect for Electronics Repair and PCB Desoldering

It's good wick. It makes a great secondary tool to a solder sucker tool. This wick seems to do a good job of absorbing unwanted solder. I don't think it's necessarily better than other wicks I've used, but it is absolutely not worse. And it's not too expensive, not to mention convenient.Did what it was suppose to do. Not much to say about it because it just worked right. smaller for smaller jobs.Terrific wick to use. I had a blob of solder accidentally bridge 4 points and actually spilled onto the PCB (very small points) and this fixed the problem without damaging the PCB at all. Works as it should and will buy in the future!Amamzing. It is cheap, and it helps immensely. I had trouble removing some components with the solder sucker, and the wick finished the job for me. It cleans up whatever the sucker could not take, and it can make removing components much easier.I didn`t pay attention to the width when I bought. Wider will allow for faster removal. It affords more surface area allowing for more and faster solder removal. Go wider if your area permits. I would buy again.Best wick I've used so far, very effective and sucks up solder like a sponge!It's a roll of solder wick - nothing fancy. It's smaller than it looks in the photo, the wick is 2.5 mm wide. Get a solder sucker for larger stuff, this for smaller components, job done. No complaints!NTE Wick really works. and will quickly remove old solder and not over heat the board. One of the best Solder wick I have used